如何知道正在運行的redis實例的當前配置

Question

我使用rc.local腳本啓動了redis實例。

su - ec2-user -c redis-server /home/ec2-user/redis.conf 

即使在我所提供的配置文件（/home/ec2-user/redis.conf）予指定

protected-mode no 

連接到redis的實例仍然產生以下錯誤消息：

Error: Ready check failed: DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside. 

我該怎麼做才能檢查正在運行的redis的當前配置？

Answer 1

localy連接到您的Redis和運行：

127.0.0.1:6379> CONFIG GET protected-mode 

你會得到當前運行值。

您可以使用多個日誌運行服務器：

redis-server /etc/myredis.conf --loglevel verbose 

問候，